MakerProof

The printer

Electricity

Wear parts

Your time (optional)

Leave the minutes at 0 for the printer's own cost. Add them if each printing hour takes some of your time too, for loading, checking or clearing the plate.

Cost per hour

£0.25for an hour of printing, before filament
Electricity · 0.12 kWh at £0.27
£0.03
Machine wear · £700 over 5,000 hours
£0.14
Wear parts
£0.08
Cost per hour
£0.25

Filament comes on top

This is what it costs to have the printer running. Filament, waste and failed prints depend on the print, not the hour, so the print cost calculator adds them to the hours a print takes.

Work out what a whole print costs

Every part of the hourly cost is shown, so you can see which one matters on your printer. How much a 3D printer costs to run, line by line

How the cost per hour is worked out

Each part of the hourly cost is its own line. Add them up and you have what an hour of printing costs before filament.

A worked example

These are the figures the calculator opens with: a £700 printer you expect to last 5,000 printing hours, drawing 120W on average, with electricity at £0.27 a kWh.

Electricity0.12 kWh at £0.27£0.03
Machine wear£700 ÷ 5,000 hours£0.14
Wear partsnozzles, belts, build plates and fans£0.08
Cost per hour£0.25

So a 4-hour print costs £1.00 in printer time before any filament. Add 6 minutes of your time per printing hour at £12 an hour and the hour goes from £0.25 to £1.45.

Common questions

How much does a 3D printer cost to run per hour?

About £0.25 an hour for a £700 printer that lasts 5,000 printing hours, before filament. That is £0.14 for the machine wearing out, £0.08 for wear parts and £0.03 for electricity. A dearer printer, or one you expect to last fewer hours, costs more.

How much electricity does a 3D printer use?

A filament printer averaging 120W uses 0.12 kWh an hour, which is £0.03 at £0.27 a kWh. The heated bed draws hard at the start and then cycles, so the average is well under the power supply's rating. A plug-in energy monitor gives you your own figure.

Which part of the cost is biggest?

On most printers it is the machine wearing out. Electricity is the part people ask about, and it is usually the smallest. That is why a long print of a cheap item can lose money even when the filament costs very little.

How many hours does a 3D printer last?

There is no single figure. It depends on how hard you run it and what you replace along the way. Count hours spent printing, not hours since you bought it. If you are not sure, use a lower number. It gives a higher hourly cost, so you are less likely to price too low.

How do I get the cost of one print from this?

Multiply the hourly figure by the print time, then add the filament, the waste and an allowance for failed prints. The print cost calculator does all of that in one go.

Does this include VAT?

No. Every figure here excludes VAT and sales tax. Enter your prices without VAT if you are registered, so the figures match your accounts.

Put this calculator on your own site

Free to embed, on any site, with no attribution required beyond the small credit link the calculator carries. Paste this where you want it to appear.

Works on a plain HTML page with no build step. The frame sizes itself to its contents, so it stays readable on a phone; the height attribute is only a fallback if scripting is off.

Find out what your prints actually cost

Free for unlimited filament and your first three licences, and the cost engine is on every plan. No card needed.